Page 31 of 59
To Configure “Settings”, See Fig. 2.
A:
Protocol for the Com Port
Choices are
TAP
, PET and TAP,
COMP1, COMP2, WaveWare and
Scope.
B:
Settings for the Com Port
Choices are Verbose or Non-Verbose
and Baud Rates of 300, 1200, 2400
and
9600
with Connection Settings of
N 8
, E 7 or 0 7.
C:
Restore Defaults Button
Click on this Button to “
Restore
”
Settings to
Factory Defaults.
D:
Advanced Encoder Settings
Button
Click on this Button to open the
“
Advanced
” Encoder Settings Screen
for more Options. See next page.
Fig. 2 (Encoder Settings Screen)
To Configure Advanced Encoder Settings, See Fig. 3.
“Defaults”
are as Shown below.
A
:
Carrier Detect
0v
B
:
Transmitter Duty Cycle
66%
and Carrier Signal
Detection is “
ON”
C
:
Data Encoding Polarity
Normal
D
:
Max Messages per Batch
10 and Increment Cap Codes
by 8 is “
OFF
” (Not Checked)
E
:
Settings for Com Port
Serial Port RESET of Timed
Paging is
Checked
and
Flow Control- Setting is set to
Hardware (RTS/CTS)
F
:
Restore Defaults
This Button will set the Entire
Screen to
Original Factory
Default Settings.
Fig. 3 (Advanced Encoder Settings Screen)
This Completes the “Com Port Settings”.
