Page 15 of 59
On the Main Screen of Encoder Setup Program, Click on “Group Paging” to Open the Pager Database.
See Fig. 8
Fig. 8 (Group Paging)
Pager Groups Screen: Enter The Group ID and list the pager ID’s you want in that group. The ID’s must be in the
Pager Families, programmed previously. Note: In most cases you would use a “Common” Pager Cap Code in the
Pager themselves instead of using Pager Groups. Using a Common Cap code will page all pagers at the same
time; whereas using a group will page each pager one at a time, which is slow. Pager Groups would be used
primarily when “Timer Active” Mode is needed. When finished, Click
“OK”.
Below See Fig. 9
Fig. 9 (Pager Groups Setup) If Group 1 is
RED
, click on the Box to Activate that Group, it will turn
Green
.
