Page 19 of 59
To enter the “Advanced Encoder Settings” Screen you must type in the User ID
“Maint”
(Not Case Sensitive)
.
Click
“OK”.
See Fig. 15
Fig. 15 (Enter Password
“Maint”
)
Below is the Advanced Encoder Settings Screen.
In MOST cases you will NOT have to adjust these settings.
The “Restore Defaults” Button will set each field back to the original default settings and affects the Entire
screen. When finished, Click
“OK”.
See Fig. 16
Fig. 16 (Default Settings)
Advance Encoder Settings
–
“Default Settings”
: (As Shown) Fig. 16
A
: Carrier Detect = 0v
B
: Transmitter Duty Cycle = 66% and Carrier Signal Detection is “ON”
C
: Data Encoding Polarity = Normal
D
: Max Messages per Batch = 10 and Increment Cap Codes by 8 is “OFF” (Not Checked)
E
: Settings for
Com Port = Serial Port RESET of Timed Paging (Checked) and
Flow Control- Setting = Hardware (RTS/CTS)
F
: Restore Defaults- This Button will set the Entire Screen to Original Factory Default Settings.
