Wavespan Stratum 100, Installation And Maintenance Manual, Page: 48 / 67

40
••
Maintaining and Monitoring the Stratum 100 Stratum 100 Installation and Maintenance Guide
------------------------------------ Reports ----------------------------------
System Status: OPERATE - NOT CONNECTED - ALARM NEW [ Alarms & Events.. ]
System Name: DEFAULT
System Uptime: 1999-03-11,13:34:59.0
IDU Temperature: 0
ODU Temperature: 0
RSSI: 0
[ T1 Channel 1 Status ]
[ T1 Channel 2 Status ]
[ Modem Status ]
[ LAN Status ]
[ Session Status ]
[ RF Link Status ]
[ ^Cancel ]
------------------------------------------------------------------------------
Checking that Packets are Going Over the Wireless Link
Use the down arrow to select RF Link Status. Press Enter to display that report.
--------------------------------- RF Link Status -----------------------------
System Status: STBY - NOT CONNECTED - ALARM [ Alarms & Events.. ]
----- Local ----- ----- Remote -----
Tx Pkt Count: 763 ?
Tx Byte Count: 48832 ?
Rx Pkt Count: 0 ?
Rx Byte Count: 0 ?
Rx Bcast: 0 ?
Rx Mcast: 0 ?
Rx Corrupt Packets: 0 ?
Rx Overruns: 0 ?
------------------------------------------------------------------------------
[ RF Pkt Interval ] [ RF Error Interval ]
Start Time: 1999-03-15,10:43:52.0 [ ^Update ] [ Clear ] [ ^Cancel ]
------------------------------------------------------------------------------
When the link is working correctly, the Rx Corrupt Packets and Rx Overruns should both
be zero.
When packets are being transmitted, the Tx Packet Count and the Rx Packet Count fields
will increase as data is transmitted across the wireless link. To verify that these counts are
increasing, wait for a few seconds and then press Ctrl U to update the counters.
Choosing RF Pkt Interval will display a screen that shows packet intervals. <<??>>