Wavespan Stratum 100, Installation And Maintenance Manual, Page: 31 / 67

Stratum 100 Installation and Maintenance Guide Installation
••
23
Verifying Ethernet Connectivity
From the Main Menu, use the down arrow to highlight the [ Diagnostics ] selection and
press Enter to go to the Diagnostics menu.
------------------------------ Diagnostics ------------------------------------
System Status: STBY - NOT CONNECTED - ALARM NEW [ Alarms & Events.. ]
------------------------------ Ping Test --------------------------------------
Target IP Addr: [0.0.0.0 ] Target:
Timeout (seconds): [0 ] Count: 0
[ Start_Ping ] [ Stop_Ping ]
------------------------------ Loopback Tests ---------------------------------
T1 Ch 1: [DISABLE]
T1 Ch 2: [DISABLE]
System: [DISABLE]
[ Apply_Loopback ]
------------------------------ BER Tests --------------------------------------
Channel: [T1_Ch1] Test: [Mark ]
Time: 0 Errors: 0 Rate: 0
[ Start_BER ] [ Stop_BER ] [ Reset_Counters ]
------------------------------ Other Tests ------------------------------------
[ View Power-On-Self-Test Results ] [ ^Cancel ]
-------------------------------------------------------------------------------
To verify Ethernet connectivity, enter the IP address of the remote Stratum 100 in the Target
IP Addr: field. Set the Timeout value with the number of seconds to perform the ping test.
Pings will be sent once per second for the specified time.
Use the down arrow to highlight the [ Start_Ping ] choice and press Enter to begin the test.
As the test proceeds, the Target field will be updated to show if the target responded. This
field will display Not Found if the target does not respond. If the target responds correctly,
this field will display Alive .