Wavespan Stratum 100, Installation And Maintenance Manual, Page: 30 / 67

22
••
Installation Stratum 100 Installation and Maintenance Guide
Step 5. Connecting to Ethernet
Connecting the Hardware
Note : The MII port and 10Base-T port cannot both be used at the same time. Also, the AUI
port is only half duplex.
Attach a data cable (not provided) to the 100Base-TX port on the Indoor Unit. . For a hub or
switch, use a straight through data cable. For a router use a crossover cable.
Install the snap-on ferrite filter as close as possible to the rear panel RJ-45 connector as
shown. This snap-on filter is required on the 10Base-T cable for FCC certification of the
Indoor Unit.
Plug the other end of this data cable into your network .
Setting the Ethernet Parameters
From the System Administration Menu, use the down arrow to go to Ethernet Config and
press Enter to go to the Ethernet Configuration menu.
------------------------------ Ethernet Configuration -------------------------
System Status: OPERATE - CONNECTED - OK [ Alarms & Events.. ]
--------------------------- Physical Interface --------------------------------
Auto Negotiation: [Disabled]
Speed: [10 Mb ]
Duplex: [Half-Duplex]
Interface Type: [RJ45]
--------------------------- TCP/IP --------------------------------------------
IP Address: [192.168.3.202 ]
IP Subnet Mask: [255.255.255.0 ]
Default Gateway: [192.168.3.1 ]
--------------------------- Spanning Tree--------------------------------------
Spanning Tree State: [Enabled ]
Hello Time: [2 ] Bridge Priority: [32768]
Forward Delay: [15 ] Port Cost: [100 ]
Max Age: [20 ] Port Priority: [128 ]
[ ^Apply ] [ ^OK ] [ ^Cancel ]
-------------------------------------------------------------------------------
Use the down arrow to go the Physical Interface section of the screen. You must either
enable Auto Negotiation or specifically set the speed and duplex. (These fields are toggled
by pressing the space bar.) You must also specify the Interface Type (RJ45 or MII).
The IP address information in the TCP/IP section is only required if you will be accessing the
unit remotely via Telnet.
If you wish to use spanning tree, you can set those parameters now.
Press Ctrl A to save (apply) your changes. Use the down arrow to go to OK and press Enter
to leave this menu.
Connecting Ethernet to the Other IDU
Connect the Ethernet cable to the second IDU in the same manner as the first one. Use the
console port to set the Ethernet parameters.