Wavespan Stratum 100, Installation And Maintenance Manual, Page: 44 / 67

36
••
Maintaining and Monitoring the Stratum 100 Stratum 100 Installation and Maintenance Guide
Using SNMP
Once the Stratum 100 is installed, you can use SNMP to manage and monitor it. To enable
traps by your SNMP manager, you must first access the Stratum 100 through some other
method (e.g. through the console port) and configure SNMP access.
To enable SNMP management, select System Admin.. from the main menu. Then choose
SNMP from the System Administration screen.
------------------------------- SNMP Management ---------------------------
System Status: STBY - NOT CONNECTED - ALARM [ Alarms & Events.. ]
Read Community String: [public ]
Write Community String: [private ]
Trap Community String: [snmptrap ]
SNMP Trap Destinations IP Addr Screening
---------------------- ----------------------
[0.0.0.0 ] [0.0.0.0 ]
[0.0.0.0 ] [0.0.0.0 ]
[0.0.0.0 ] [0.0.0.0 ]
[0.0.0.0 ] [0.0.0.0 ]
[0.0.0.0 ] [0.0.0.0 ]
SNMP Agent: [Disabled]
IP Screening: [Disabled]
[ ^Apply ] [ ^OK ] [ ^Cancel ]
-------------------------------------------------------------------------------
Enter the desired values on the SNMP Management screen. Then choose the SNMP Agent
field and use the space bar to toggle the value to Enabled.
Choose Apply to save your changes and then select OK to close the screen.
Dialing Out with Alarms using SNMP
You can also configure the AUX port to be used as a dial out line to send SNMP traps to a
specified location. To do this, choose
System Admin from the main menu. From the System
Administration screen, select Modem Config to set up the dial out information.