Wavespan Stratum 100, Installation And Maintenance Manual, Page: 24 / 67

16
••
Installation Stratum 100 Installation and Maintenance Guide
Setting the IP Address (Optional)
If you wish to access the IDU through Telnet for remote management, you must assign an IP
address. If you will not be accessing the unit remotely, you can skip this step.
From the System Administration Menu, use the down arrow to go to Ethernet Config and
press Enter to go to the Ethernet Configuration menu.
If you wish to manage the system remotely via SNMP, you must set an IP address.
------------------------------ Ethernet Configuration -------------------------
System Status: OPERATE - CONNECTED - OK [ Alarms & Events.. ]
--------------------------- Physical Interface --------------------------------
Auto Negotiation: [Disabled]
Speed: [10 Mb ]
Duplex: [Half-Duplex]
Interface Type: [RJ45]
--------------------------- TCP/IP --------------------------------------------
IP Address: [192.168.3.202 ]
IP Subnet Mask: [255.255.255.0 ]
Default Gateway: [192.168.3.1 ]
--------------------------- Spanning Tree--------------------------------------
Spanning Tree State: [Enabled ]
Hello Time: [2 ] Bridge Priority: [32768]
Forward Delay: [15 ] Port Cost: [100 ]
Max Age: [20 ] Port Priority: [128 ]
[ ^Apply ] [ ^OK ] [ ^Cancel ]
-------------------------------------------------------------------------------
Use the down arrow to go the TCP/IP section of the screen and enter the IP Address , IP
Subnet Mask, and Default Gateway (if needed).
Press Ctrl A to apply your changes. Use the down arrow to go to OK and press Enter to leave
this menu.
You have now specified all of the basic configuration parameters for the IDU and you can
unplug the computer from the console port.
Setting up the Second IDU
The second IDU unit should be installed and configured in exactly the same way. Note that
you must use the
same Link ID for the second IDU.