4 of 36
Tools Required
• tekmar or jeweler screwdriver
• Phillips head screwdriver
• Wire stripper
• Drill (for wall anchor)
• 3/16" drill bit (for wall anchor)
Preparation
---------------------------------------------------------
---------------------------------------------------------
Removing The Thermostat Base
--------------------------------------
--------------------------------------
Materials Required
• 18 AWG LVT Solid Wire (low voltage connections)
Installation Location
-------------------------------------------------
-------------------------------------------------
Consider the following:
• Interior wall.
• Keep dry. Avoid potential leakage onto the control.
• Relative humidity less than 90%. Non-condensing environment.
• No exposure to extreme temperatures beyond 32-122°F (0-50°C).
• No draft, direct sun, or other cause for inaccurate temperature readings.
• Away from equipment, appliances, or other sources of electrical interference.
• Easy access for wiring, viewing, and adjusting the display screen.
• Approximately 5 feet (1.5 m) off the finished floor.
• The maximum length of wire is 500 feet (150 m).
• Strip wire to 3/8" (10 mm) for all terminal connections.
• Use standard 8 conductor, 18 AWG wire.
While holding the base section in one hand, pull
the lower half of the display front towards you to
pivot it away from the base.
Installation