background image

Limited Warranty

•   The OneFlow

®

 tank system is warranted to be free of defects in materials and workmanship for 5 years from the date of original shipment.

•   The OneFlow

®

 media is warranted for performance for a period of 2 years from the date of the original installation when installed and oper-

ated in accordance with the instructions in the corresponding Installation and Operation Manual.

Watts Regulator Company warrants its OneFlow

®

 cartridge systems as follows:

•   The OneFlow

®

 cartridge system is warranted to be free of defects in materials and workmanship for 1 year from the date of original 

shipment.

•   OneFlow

®

 cartridges are warranted for performance for a period of one year from the date of original installation when installed and 

operated in accordance with the instructions in the corresponding Installation and Operation Manual.

•   Carbon replacement filter cartridges are not warranted to perform for any period of time because the service life of replacement carbon 

filter cartridges varies significantly with local water conditions and volume.

Conditions

1.   The OneFlow

®

 system must be installed in applications with municipally supplied water adhering to EPA guidelines. 

2.  Any component failure must not result from abuse, fire, freezing or other acts of nature, violence, or improper installation.
3.  Equipment must be installed and operated in compliance with the local plumbing codes and on an approved water supply.
4.  Equipment is limited to use at water pressures and temperatures that do not exceed our published specifications.
5.   Water supply must not exceed 2.0 PPM chlorine.  For water supply exceeding 2.0 PPM chlorine, pretreatment is required.  

(Please contact your water treatment specialist.)

6.   Information, including model number, serial number, and date of installation, must be provided for any claims pertaining to equipment in 

warranty.

7.   Defective parts are subject to inspection by either Watts Regulator Company or any authorized representative before final commitment of 

warranty adjustment is made.

8.   Watts Regulator Company reserves the right to make changes or substitutions in parts or equipment with material of equal quality or value 

and of then current production.

Limitations

Our obligation under this warranty with respect to the tank or valve is limited to furnishing a replacement for, or at our option, repairing any 

part or parts to our satisfaction that prove defective within the warranty period stated above.  Such replacement parts will be delivered to the 

owner F.O.B. nearest factory, at no cost, excluding freight and local labor charges, if any.
Our obligation under this warranty with respect to the OneFlow

®

 media will be limited to furnishing a replacement for the media within two 

years from date of original installation.  Such replacement media will be delivered to the owner F.O.B. nearest factory, at no cost, excluding 

freight and local labor charges, if any.  Damage to the media due to chlorine, other oxidizers or fouling caused by local water conditions or 

any other operation outside of the limits shown under Specifications, is not covered by this warranty.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY WATTS REGULATOR COMPANY 

WITH RESPECT TO THE PRODUCT.  WATTS REGULATOR COMPANY MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED.  WATTS 

REGULATOR COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT 

LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  
The remedy described under this warranty shall constitute the sole and exclusive remedy for breach of warranty, and Watts Regulator 

Company shall not be responsible for any incidental, special or consequential damages, including without limitation, freight, handling, lost 

profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting from 

labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any 

other circumstances over which Watts Regulator Company has no control.  This warranty shall be invalidated by any abuse, misuse, misap-

plication or improper installation of the product.  
Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of inci-

dental or consequential damages.  Therefore the above limitations may not apply to you.  This warranty gives you specific legal rights, and 

you may have other rights that vary from state to state.  You should consult applicable state laws to determine your rights.  SO FAR AS IS 

CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED 

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE APPLICABLE 

WARRANTY PERIODS STATED ABOVE.

IOM-OF140-4 1017 

EDP#2915002 

© 2010 Watts 

USA:

  815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com

Canada:

  5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca

A Watts Water Technologies Company

Summary of Contents for OneFlow OF140-4





















Reviews: