www.enware.com.au
© Enware Pty Ltd
Page 3
1. Fit 1/2” Tail into Base Mount:
Apply thread sealing tape onto the
non-bevelled end of 1/2” BSP all-thread
tail, and screw to female thread of hob
base.
2. Mark the hole to be drilled on the bench
(min. 40mm - max. 160mm to the centre
from wall) and drill the hole (
Φ
22mm)
using a hole saw or similar tool. SEE
IMAGE 3
3. For tap base with anti-rotation pins,
note the orientation of the tap handle
(standard is either facing the front or
to the right hand side). Check the
positions of the two anti-rotation pins
on the underside of base. Mark the
corresponding pin locations onto bench
and drill 2x holes (
Φ
9mm).
4. Fit base onto the bench and secure
using 1/2” brass nut from underneath the
bench.
For base with anti-rotation pins, fit black
spacer first (if required), then fit the nut,
and tighten firmly. Do not over-tighten.
(Using excessive force may result in
damage to the black plastic spacer.) SEE
IMAGE 5.
5. Proceed to Fitting Lever Handles – page
12
IMAGE 1
IMAGE 4
IMAGE 2
Single inlet hob tap
assembly - Maximum
bench thickness: 35mm
Hob base mount -
Maximum bench
thickness: 10mm
9
22
33 mm
40 mm MIN -
160 mm MAX
WALL
9
IMAGE 3
IMAGE 5
hob mounted single inlet
FS011 FS010
