www.enware.com.au
© Enware Pty Ltd
Page 4
1. Mark the hole to be drilled on the bench
(min. 40mm - max. 160mm to the centre
from wall) and drill a
Φ
33mm hole using
a hole saw or similar tool.
2. Unscrew metal washer and fixing nut
from body assembly.
Fit one flexible inlet hose onto body.
Apply a small amount of food grade
grease onto O-ring before fitting. (Note
markings on flexible hose – red [for hot]
and blue [for cold])
3. Fit base onto bench through the drilled
hole. From underneath the bench, fit
large metal washer before fitting the
brass locking nut. Hand-tighten locking
nut. Check that tap base is facing
straight forward, then use a Philips head
screw driver to firmly tighten the two
screws on either sides of brass nut.
4. Fit the other flexible inlet hose onto body.
5. Proceed to Fitting Lever Handles – page
12
IMAGE 7
33
40 mm MIN -
160 mm MAX
WALL
IMAGE 6
IMAGE 8
IMAGE 10
IMAGE 9
Maximum bench thickness: 30mm
hob mounted twinner body
FS015
