www.enware.com.au
© Enware Pty Ltd
Page 13
Note that each component of the pre-rinse assembly uses a corresponding male-double-O-ring-spigot to
female-socket swivel connection. The O-rings on the male spigot are pre-greased. Re-grease them if required.
1. Take grub screws out from female joints of all parts
(riser, pot filler adaptor, base, body) and keep them at
hand.
2. Fit riser and/or pot filler adaptor onto the base body.
To do this, firstly align the joints straight, then gently
but firmly push the male double O-ring spigot fitting
into the female connection, taking care not to pinch
or damage the O-rings while doing so. Push the
joints together all the way until the male joint comes
to a stop.
3. Check that the riser is sitting plumb (straight up).
Measure the distance between the wall and the riser.
4. Assemble the wall bracket, making sure that there
is enough thread going into the wall plate and the
half section of the riser bracket. Note the difference
in length from the measurement taken in step 3. Cut
the all-thread to suit (if required).
5. Re-assemble the bracket, and fit the bracket onto
the riser as high up as possible. This gives greater
support and stability to the assembly. Gently tighten
the two screws of the bracket onto riser using the
2.5mm Allen key provided.
installing the riser, pot filler & spray arm
IMAGE 35
IMAGE 35
IMAGE 36
IMAGE 33
IMAGE 34
IMAGE 32
