29
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
Step 4: Installing the Flight Battery
❑
The flight battery should be installed directly behind the
motor mount to aid in balancing.
☛
To make it easier to install the battery, use a modeling
knife to cut away and remove a portion of the fuselage
between the forward and middle cutouts.
IMPORTANT
We strongly suggest cutting two 1/4" diameter air-intake holes in the front of the plastic wing mount to allow cool air to
pass over the flight battery. This will keep the battery from over-heating.
Step 5: Installing the Pilot Figure
❑
Using a pair of scissors, carefully cut out each of the two
pilot figure decals along their outer edges.
❑
Apply one decal to one side of the 37mm x 50mm piece
of sheet-foam.
❑
Using a sharp modeling knife, carefully trim the sheet-foam along the outer edges of the decal.
❑
Apply the second decal to the opposite side of the sheet-foam.
❑
Mount the pilot on top of the fuselage using a narrow
strip of double-sided tape.
