5
TAPPING INTO THE COLD WATER LINE
A
- (Using the water supply adaptor Part #
PPASV121208W
)
For flex metal or plastic line.
NOTE: The Millennium
®
drinking water system must be connected to the COLD water
supply only.
1) Turn off the
cold
water supply to the sink faucet by locating the round or oblong
handle and turning clockwise until the water supply is off.
NOTE: If the cold water shut off valve fails to turn off the water, the house supply can
be turned off at the main water supply.
2) The water supply adapter (Fig. #2) may be installed at the faucet connection
3) Disconnect the 3/8” flex line from the base of cold water basin supply angle stop
valve.
4) Re-connect the 3/8”
PPASV121208W
Angle Stop Valve to the basin supply angle
stop valve.
5) Re-connect flex line to the
PPASV121208W
Angle Supply Valve.
6) Push green tubbing in to Quick Connect fitting up to tube stop. Pull on the tubing
to check it is secure. Test the system before use.
(Fig. 2)
NOTE: All local plumbing codes must be follewed to ensure proper installation and
use of your MILLENIUM system.
CAUTION: A pressure regulator is recommended for feedwater pressure above 80psi.
Flex metal or plastic line
going towards sink faucet
3/8 Compression thread
3/8 Compression thread
Cold water basin supply
angle stop valve
Quick Connect
Green tubing going
towards RO
PPASV121208W Angle Valve
Summary of Contents for new millenium
Page 2: ...Distributed by Serial...
