4211-1661 01/28/2022
APPENDIX: SYSTEM INSTALLATION
APPENDIX: SYSTEM INSTALLATION
page 5
DIAGRAM 8: LOCATING THE STEAM HEADS
12” MIN
(305 mm)
18” MIN
(46 mm)
12” MIN
(305 mm)
18” MIN
(46 mm)
6” MIN
(150 mm)
12” MIN
(305 mm)
12” MIN
(305 mm)
IMPORTANT
The steam pipe entry into the steam
room and the steam head must be
caulked to avoid damage caused
by steam leakage into the wall.
Centering the steam pipe is critical
through walls made of plastic,
acrylic, resin, fiberglass, or similar
materials. Allowing the pipe to touch
materials not rated for 212°F (100°C)
or higher will result in damage
to these materials.
If the steam line is in an area where the
temperature will be below 40°F (4°C) or
if the line is more than 20 feet (6 m) long,
insulate the steam line for best results.
SECTION 5: WIRING INSTRUCTIONS
1.
ELECTRICAL ROUGH-IN
Use correct size and type of power wires and circuit breakers to meet electrical codes. Leave 4 feet (1,2 m) of slack wire at generator location to finish hookup.
Connect each generator to a dedicated circuit breaker.
2
ELECTRICAL FINISH
At the generator, route the copper supply wire with an appropriate strain relief through the hole marked POWER ENTRY. Connect the supply wires to the power
terminal block. Refer to the wiring diagrams to determine your connection points and the necessary jumper connection. Connections can be varied to use either
single phase or 3 phase or 3 phase +Neutral. Connect the earth ground to the ground lug (green screw).
Notes
:
• Two power circuits are required for 208V WWSU11 and for 208 and 240V WWSU15.
• Supply voltage must be 200V or higher. 240V models may be used with available voltages to 240V (and 380V-415V~3N).
• Use copper power wire only! All wire is to be UL Listed, 300V 75°C minimum unless otherwise specified.
•
A GFI device is not required by UL or NEC. One may be installed if required by local codes or the owner.
A GFI device will tend to nuisance trip due to heater element aging.
3.
CONNECT STEAMERS TOGETHER
Connect a control cable from the Primary steamer’s G1 or G2 jack to the secondary steamer’s AK IN jack. Repeat for the third steamer, if installed. Note: We
recommend system steamers be of similar wattages and, if not the same, the largest wattage should be in the primary steamer.
See diagram below.
1
4
5
8
100mA TIME DELAY
3224-
1A NON-TIME DELAY
+
SVC
+
+
WATER
S60 B
S60 A
S30A
G2
AK I
N
60m/24HR
NORM/EXT
F/ C
12
3
OO
DRAIN
W-D COM
S30B
G1
2403-23 REV. B
C
SAUNATEC 2016
K1
K6
K3
K4
K5
K2
J15
K8
K7
F2
F1
VR1
C20
C19
C21
BR1
J1
8J
17
J1
9
L
H
R
J4
D14
J10
G2
12 3
G1
G2
AK I N
12 3
G1
G2
AK I N
12 3
G1
DIAGRAM 9: CONNECTING STEAMERS
PRIMARY STEAMER
SECONDARY STEAMER
SECONDARY STEAMER
