18
INPUT VOLTAGE:
110-120VAC @ 60Hz
OPERATING VOLTAGE:
12VAC @ 60Hz
MIN WORKING PRESSURE:
20-150 psi
138-861 kPa
MIN OPERATING TEMPERATURE:
40°-110° F
4.4-43.30° C
MAX FLOW TO DRAIN DURING REGENERATION:
2.2 gpm
8.3 l/min
FOR GENERAL INSTALLATION CONDITIONS, PLEASE SEE CARE & USE GUIDE.
THE REIONATOR PRO ULTRA™ IS A DIR (DEMAND INITIATED REGENERATION) SOFTENER WHICH
COMPLIES WITH SPECIFIC PERFORMANCE
SPECIFICATIONS INTENDED TO MINIMIZE THE USE OF REGENERANT BRINE IN ITS OPERATION.
THIS WATER SOFTENER CONFORMS TO NSF/ANSI 42 FOR REDUCTION OF AESTHETIC CHLO-
RINE AND NSF/ANSI 44 FOR SOFTENING EFFICIENCY AS VERIFIED AND SUBSTANTIATED BY
TEST DATA. WHILE TESTING WAS PERFORMED UNDER LABORATORY CONDITIONS, DUE TO
VARYING WATER CONDITIONS ACTUAL PERFORMANCE MAY VARY.
THE REIONATOR PRO ULTRA HAS BEEN TESTED ACCORDING TO NSF/ANSI 42 FOR THE
REDUCTION OF THE SUBSTANCES LISTED IN THE TABLE TO THE RIGHT. THE CONCENTRA-
TION OF THE SUBSTANCE IN THE WATER ENTERING THE SYSTEM WAS REDUCED TO A
CONCENTRATION LESS THAN OR EQUAL TO THE PERMISSIBLE LIMIT FOR WATER LEAVING
THE SYSTEM AS SPECIFIED BY NSF/ANSI 42.
THE REIONATOR PRO ULTRA IS NOT INTENDED FOR USE IN TREATING WATER THAT IS MI-
CROBIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION
BEFORE AND/OR AFTER THE SYSTEM.
USAGE OF THE REIONATOR PRO ULTRA IN A MANNER OTHER THAN PRESCRIBED IN THE
MANUFACTURER’S WARRANTY WILL VOID THE REIONATOR LIMITED LIFETIME WARRANTY.
(SEE OWNER’S MANUAL FOR FULL WARRANTY INFORMATION.)
AS WITH ANY APPLIANCE, PROPER OPERATION AND MAINTENANCE IS REQUIRED
TO ENSURE TROUBLE-FREE OPERATION. PLEASE CONSULT YOUR LOCAL AUTHO
-
RIZED WATERTECH DEALER FOR SERVICE.
Model
*1
Softening Efficiency @
Stated Salt Setting
(Grains Per Pound)
2
Softening Capacity @
Stated Salt Setting
(Grains Per Gallon)
Maximum Recom
-
mended Hardness
(Grains Per Gallon)
Maximum Recommend
-
ed Flow Rate / Service
Flow Rate (Gallons per
minute)
Maximum Flow to
Drain During
Regeneration
(Gallons per minute)
@PSID
Total Bed
Depth (FT
3
)
RXU13
3998 @ 4.7 lbs.
18,901 @ 4.7 lbs.
45
11.0
2.2
15
2.350
Model
Aesthetic Chlorine
Reduction (Gallons)
RXU13
1180
*
The efficiency is only valid at the stated salt dosage and maximum service flow.
1
Softening efficiency values based on NaCl as the regenerant salt.
2.
Softening capacity values based on NaCl as the regenerant salt.
Specifications
WaterTech recommends the use of Potassium Chloride (KCl) as a regenerant salt.
Efficiency rated softeners shall have a rated
salt efficiency of not less than 3350 grains
of total hardness exchange per pound of
salt, and shall not deliver more than its
listed rating.
