IMPORTANT NOTICE:
Read this performance data sheet and compare
the capabilities of this unit with your actual water
treatment needs.
FEATURES:
• Finely polishes treated water to premium
quality for drinking and cooking.
• Reduces chlorine, taste and odour.
• Reduces dirt, rust, asbestos fibres and other
particulates such as oxidized iron, manganese
and sulphides.
• Reduces parasitic protozoan cysts such as
Giardia, Entamoeba and Cryptosporidium.
• Absorbs common earthy, mouldy, fishy tastes
and odours.
HEALTH CLAIM PERFORMANCE CLASSIFIED
BY NSF.
This system has been tested according to NSF/
ANSI 42 and 53 for the reduction of the substances
listed below.
The concentration of the indicated substances
in water entering the system was reduced
to a concentration less than or equal to the
permissable limit for water leaving the system, as
specified in NSF/ANSI 42 and 53.
OPERATING SPECIFICATIONS:
• Capacity: 2,875 litres
• Pressure Requirement: 10-125 psi
(0.7 - 8.6 bar), non-shock.
• Temperature: 2-38°C
• Flow Rate: 1.9 litres per minute.
GENERAL INSTALLATION / OPERATION/
MAINTENANCE REQUIREMENTS:
• Space required: 34cm x 13cm including 6cm of
clear space for cartridge change.
• Install vertically
• Flush new cartridge at full flow for 2 minutes
until air is purged.
• Replace cartridges when capacity is reached,
or when flow becomes too slow, but at least
annually.
SPECIAL NOTICES:
• This drinking water system must be maintained
according to manufacturer’s instructions,
including replacement of filter cartridges.
• Do not use with water that is microbiologically
unsafe, or of unknown quality without adequate
disinfection before or after the system.
• The contaminants or other substances removed
or reduced by the water treatment system are
not necessarily in your water.
• Check for compliance with state and local laws
and regulations.
• Tested under sustained standard laboratory
conditions, actual performance may vary.
FILTER SYSTEM
WFA Premium Water Filter System
Model No:
WFA12