Key features of the Firebox V10 security appliance
Installation Guide
7
Make sure, too, that the cable is the correct
type for the connection. If connecting the
Firebox V10 appliance to a hub or switch, a
straight-through
cable is needed (two 3-ft.
10/100 cables are provided). If connecting
directly to a computer, a
crossover
cable is
required (a 6-ft. 10/100 crossover cable is
provided).
Console interface
A single DB-9 interface, labeled
Console
,
permits a direct workstation-to-appliance
connection, at which time you can use the
WatchGuard command line interface
(CLI) to configure and administer this
appliance. To learn more about this
administrative option, open and review
the
WatchGuard CLI User Guide
(included
on the installer CD).
5Vdc3.0A power interface
This interface serves as the connection to a
100VAC-to-240VAC (50/60Hz) source.
Use the power cord supplied in the
package to connect this appliance to a UPS
device or to a power outlet.
N
OTE
The power supply can auto-detect 110/220 voltage.
Appliance reset
This opening allows you to insert a straight pin or
paperclip and press an internal Reset switch that
restarts the appliance. This is an option to
unplugging and replugging the power cord.
N
OTE
IN THE EVENT OF A POWER FAILURE… this security appliance, if
left connected to the power source, will automatically restart itself once
electrical power has been restored. You do not have to unplug and then
reconnect the appliance to the power source.
1install_guide.book Page 7 Friday, June 7, 2002 1:10 PM
