INTRODUCTION
© WASP S.r.l.
53
Ordinary and extraordinary maintanance
Fig. 7.2.6 - Changing the nozzle
1. Turn on the printer
2. Set nozzle and barrel to the last temparatures used and wait until they’re reached
3. Remove the Silicone Ooze shield protection as described in par. 7.2.8 “Ooze shield protection”
4. Unscrew and remove the nozzle using the provided tool, pay attention to the hot surfaces.
5. Tighten back the new nozzle fixing it in its position.
6. Fix the Silicone Ooze shield protection as described in par. 7.2.8 “Ooze shield protection”
7. Use the PRINT>CLEAN EXTRUDER command
After a nozzle replacement is recommended to perform the Autocalibration procedure (see paragraph 8.2
Autocalibration).
fig 7.2.6 a
fig 7.2.6 b
Summary of Contents for 4070 HDP
