Wascomat Selecta S28/125, Operating & Maintenance Manual

Page: 28 / 76

21
Mechanical and electrical design
36
1726
Panels
The machines are equipped with a top panel made of stainless steel. The
front panel is available in different colours or in stainless steel. The col-
oured panels are made of phosphatized steel plate. For servicing purposes,
the panels can easily be removed.
Back gable and bearing
The back gable and the bearing trunnion housing are constructed of a
webbed heavy casting for extra rigidity. The bearings are protected against
filtration of water by three neoprene seals. An intermediate safety outlet
provides an escapement for any possible condensation.
The seals are mounted on a stainless steel sleeve bushing that is mounted
on the drive shaft to prevent wear of the seals and shaft. The main bearing
is fitted machinetight into the bearing trunnion housing. A nut is tightened
on the shaft to prevent the cylinder from moving in and out.
The extension of the bearing trunnion housing supports the rear bearing
holding the shaft. A grease seals is mounted to prevent escape of grease.
The bearings are permanently lubricated and need no maintenance.
Fig.
36
S28/125
C-clamp
Rear bearing
Rear lining
Inner drum
Bushing
Seals
Bearing housing
Front bearing