INSTALLATION & USER MANUAL
6
Installation and User Manual
7
Revision 8.12.2015
INITIAL REMOTE SETUP and CONFIGURATION
•
The following are applicable for configuring the main remote only. To configure additional remotes, refer to 'Multiple
Remotes' for more information.
•
Pressing
MODE
does not work when zone in remote display is set to
ALL
. Press
ZONE
to exit zone
ALL
.
•
All steps must be performed within 30 seconds or the remote control will default to the previous settings.
1. Open the remote battery cover and install the two AA alkaline batteries and replace
the cover.
2. All the screen display segments will be visible while the remote runs a self-test which
lasts for a few seconds. After which,
SET
will be displayed.
3. Press
▲ ▼
to choose either
C
(Celsius) or
F
(Fahrenheit).
4. Press
ENTER
to save your selection.
5. Press
▲ ▼
to choose either
M
(main) or
S
(secondary). Select
M
for main.
Note:
Secondary is only used when using additional remotes. Refer to 'Multiple
Remotes' for more information.
6. Press
ENTER
to save your selection.
7.
ZONE ALL
and the temperature should now be displayed.
Installation and User Manual
7
Revision 8.12.2015
INITIAL REMOTE SETUP and CONFIGURATION
•
The following are applicable for configuring the main remote only. To configure additional remotes, refer to 'Multiple
Remotes' for more information.
•
Pressing
MODE
does not work when zone in remote display is set to
ALL
. Press
ZONE
to exit zone
ALL
.
•
All steps must be performed within 30 seconds or the remote control will default to the previous settings.
1. Open the remote battery cover and install the two AA alkaline batteries and replace
the cover.
2. All the screen display segments will be visible while the remote runs a self-test which
lasts for a few seconds. After which,
SET
will be displayed.
3. Press
▲ ▼
to choose either
C
(Celsius) or
F
(Fahrenheit).
4. Press
ENTER
to save your selection.
5. Press
▲ ▼
to choose either
M
(main) or
S
(secondary). Select
M
for main.
Note:
Secondary is only used when using additional remotes. Refer to 'Multiple
Remotes' for more information.
6. Press
ENTER
to save your selection.
7.
ZONE ALL
and the temperature should now be displayed.
NOTE: The remote has been configured and paired by Wasco. Keep instructions for future use.
