Page 3
63398 D2
Note:
It will be easier to get a bolt started on each side and then insert the spacers
between the mating surfaces of the bumper and frame. Slide one spacer up in
between the bumper and frame and start both top and bottom bolts. Then move to
the next locations and repeat the insertion of the spacer. Repeat this for all of the
rear frame locations.
On some TJ and YJ models, it may be necessary to loosen the gas tank skid plate to
allow for enough hand room to access the inner bolt hole locations.
Note:
On some CJ models it may be necessary to use additional spacers to prevent
interference between the tire carrier and the tailgate hinges.
Figure 2, CJ VEHICLE, PASSENGER’S SIDE SHOWN,
DRIVER’S SIDE OPPOSITE
