WARIO ME13, User Manual

Page: 12 / 27

12
User guide for IP Weather Station WARIO ME13
weather station will reset to defaults. If the system boots correctly, the green LED diode will
flash on the control unit.
If the device is on, but the control unit is unresponsive, use the second option of resetting
the device. Turn the station off, press and hold the reset key and then plug it in. The red LED
should now be on. Release the button after 3 s and the station should now be in the default
configuration.
5
Sensor range and resolution
Range Resolution
Outdoor temperature -55 to +125 °C ± 0,5 °C (-10 to +85 °C)
± 2 °C (-55 to -10 °C a +85 to +125 °C)
Atmospheric pressure 150 to 1150 hPa ± 1,5 % (at 25 °C)
Outdoor humidity 0 to 100 % ± 5 % (10 to 60 %, at 25 °C)
± 8 % (0 to 10 % a 60 to 100 %, at 25 °C)
Precipitation 0 to 9999 mm tipping bucket capacity: 0,3 mm
Wind speed 0 to 45 m/s (160 km/h) threshold 0,5m/s
Wind direction 0 to 360 °
Solar radiation 0 to 1250 W/m2 ± 10 %
Relay outputs OUT1 and OUT2 have a maximum current of 0.25 A and voltage of 30 V.
Operating temperature of Weather station -30 to +65 °C.
S1 and S2 connectors for independent cable temperature or temperature/humidity sensors.
Range Resolution
External temperature
sensor (protection IP68) -55 to +125 °C ± 0,5 °C (-10 to +85 °C)
± 2 °C (-55 to -10 °C a +85 to +125 °C)
External temperature
/ humidity sensor -55 to +125 °C
0 to 100 % ± 2 °C (-55 to +125 °C)
± 5 % (10 to 60 %, at 25 °C)
± 8 % (0 to 10 % a 60 to 100 %, at 25 °C)
6
Device installation and configuration
Configuration and viewing all the data is done using the browser. The default IP address to
access the station is
192.168.55.56
and subnet mask
255.255.255.0
. Only the IPv4 protocol
is supported.
Network settings can be variable depending on which operating system you use and the
following default configuration of the weather station must be taken into account.
Default configuration of the weather station:
Version 4 IP protocol (TCP/IPv4)
IP address:
192.168.55.1
Subnet mask:
255.255.255.0
DNS set up:
not necessary.
To enter the homepage of the weather station control panel type the following address into
your browser address bar:
192.168.55.56
.