21
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator 9
Introduction
1.3 Good 3D Printing Practices
Please refer to these steps during every print to ensure the best quality.
Before Printing
1.
Ensure your GCODE file is correctly setup, filament diameter is set to to 1.75mm and correct
temperature settings for the material you are using (refer to table 3.1, page 27)
2.
Check all cables and connectors are connected
3.
Check that Heated Print Bed is level and approximately 0.1mm from the nozzle
4.
Check that Heated Print Bed is clean and dust free and nozzle does not have excess material
stuck to it
Always check Gcode
file settings match
filament and printer
Always check
Print Mat is clean
and there is no
residual plastic
Always check Extruder
& Print Bed
Temperatures are set
for correct filament type
Always check all
cords are
connected
Always check
Extruder distance is
0.1mm from Print Mat
Always check
Print Bed is level
During Printing
1.
Closely monitor the first layer being printed – Most problems will occur in the first layer. If
problems occur, stop the 3D Printer at the power outlet
2.
Do not leave the 3D Printer unattended while in operation
3.
Keep hands clear while machine is operating
After Printing
1.
Wait for the Heated Print Bed and Extruder to cool down
2.
Carefully remove 3D Object. Never use Scraper towards your body. Keep Scraper evenly flat
when scraping to avoid damage to the Heated Print Bed. Damaged Heated Print Bed will
affect adhesion for future prints
3.
Store 3D printer in a clean, dry environment
