Setup
2. Levelling the Heated Print Bed
It is important to ensure the Heated Print Bed is level and set to approximately 0.1mm distance
prior to printing.
1.
Press Tool
→
Move
→
Z Axis
→ +
to Riaise the extruder.So that you can easily access the
heated print bed.
2.
Turn off your 3D Printer
3.
Check the Z axis level. The X rail should be parallel to the Heated Print Bed. If it is not,
manually rotate the right hand side Z axis stepper motor to level it
4.
Squeeze each corner of the Heated Print Bed, and tighten each wing nut to reduce the
distance between plates to a minimum
5.
Wipe the top of the Heated Print Bed with a clean, lint-free cloth to ensure no dust particles or
other objects are on the surface
6.
Turn on the 3D Printer, using the switch on the back of the Control Box
7.
With the printer initialised, press Tool
→
Home All
8.
Navigate to and select
. Press Tool > Home All
. Your 3D printer will now try to align to
the ‘home’ position, on the front left corner of the Heated Print Bed
9.
Once aligned, turn off the 3D printer
10.
With the printer powered off, move the Extruder to one corner of the Heated Print Bed to
check the distance between these components
11.
Rotate the wing nut to raise the Heated Print Bed. A good distance is 0.1mm, and will allow a
sheet of paper to slide freely with slight friction between the Extruder and Heated Print Bed
12.
Move the Extruder to each of the other corners and repeat the process. Move the Extruder to
the centre of the Heated Print Bed and test the gap with a sheet of paper. Keep adjusting and
testing until the proper gap is present at all points
IMPORTANT NOTE: Levelling the bed is an extremely important step and if it is not done
correctly every time, your prints will fail or be of poor quality
26
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator 9
