Using Cura
Enable Retraction
Retraction tells your printer to pull filament out of the Extruder upon travel moves. Travel moves
are when your print head moves from one area of the print, to another without laying down
filament. We recommend keeping this on for all filament types, and adjusting the retraction length
and speed for the specific filament.
FILL
Bottom/Top Thickness (mm)
Also known as Surface Layers; this will determine how thick the top and bottom layers are. A larger
number here will create a thicker top and bottom which can be helpful for strength, bridging, and
quality purposes. We recommend using a number which is a multiple of your layer height.
Eg: If using a layer height of 0.2mm, set the thickness to 0.4, 0.6 or 0.8mm
Fill Density (%)
This number is expressed as a percentage. 0% will give a completely hollow print, while 100% will
give you a completely solid object. We recommend 20% to 40% fill density as it is functional for
most prints.
SPEED AND TEMPERATURE
Print Speed (mm/s)
Your overall printing speed can be adjusted here. If no other speeds are determined in the
later sections your printer will automatically default to this speed. This speed will be different,
depending on what type of filament you are using. We recommend setting speed to 30mm/s.
Printing Bed Temperature (C)
When using different filament materials, you’ll need to update the desired Extruder and Heated
Print Bed temperature. Any temperatures specified here will be used to automatically set both
the
Extruder and Heated Print Bed. Your print will not begin until these temperatures are met. As a
guide, refer to Table 3.1 on page 27 for temperature settings.
37
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator 9
