16
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator 9
5.
Move the Extruder to each corners of the print bed then you can adjust the bolts
under each corner. repeat the process. Move the Extruder to the centre of the Print
Bed and measure the gap with a sheet of paper. Keep adjusting and testing until you
find ensure the proper distance between nozzle and print bed.
SIDE VIEW
END VIEW
COMMENTS
Nozzle Too High:
Insufficient contact
area resulting in
poor adhesion and
extrusion skipping.
OK:
Filament pushed
into the build
surface slightly to
maximize surface
area contact while
still allowing good
extrusion flow.
NOZZLE TOO LOW:
Not enough
clearance for the
filament to be
extruded... this will
result in damage to
the extruder and/or
build surface.
RAFT MAGNIFICATION
NOTES
NOZZLE TOO HIGH:
Wavey tracks,or tracjs
narrower than 1.2mm
(use vernier callpers
to check)
NOZZLE TOO LOW:
Trancks sides pushed
over neighbouring
tracks.
CHECKING CHART
Quick Guide
NOTE:
Before proceed anything ,use a soft fabric to Wipe off the dusts from the building plate surface
and clean it. Not leveled print bed may damage the Printing bed Mat during Auto Bed Leveling.
