Setup
Alternative types of PLA
These PLA Alternatives require advanced knowledge of the 3D Printer. Please visit
www.wanhao3dprinter.com
for details of filament types and parameters.
NOTE:
Only use WANHAO Filament with your 3D Printer, using other filaments may
damage your 3D Printer and may void your warranty.
3.2 Inserting Filament:
1.
With the printer initialised, press Tool
→
Preheat
2.
Navigate to, and select Preheat PLA or Preheat ABS - depending on the material in use
3.
Wait for the 3D printer to automatically return to the home screen, after approximately 15-30
seconds
4.
Check the temperature of the Extruder and plate on
the LCD. When the temperatures are within a few
degrees of the target, you are ready to insert the filament
NOTE:
Preheat PLA/ABS will still be shown, even after
temperatures have been reached
5.
Carefully insert the included filament sample into the
hole on the Extruder as shown
6.
While holding the filament in place with one hand, press
the Dial to enter the menu system
7.
Navigate to and select Tool
→
Move
→
E Axis
→ ＋
Extruder > Extr. Position.
8.
Gently push down on the filament while turning the Dial clockwise. You will feel the filament
being pulled into the Extruder. Continue until a few centimetres have extruded out of the
nozzle
.
9.
Carefully clean the extruded filament off the Heated Print Bed and nozzle
WARNING: Extruder and Heated Print Bed will still be hot
28
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator 9
