Electrical power
This 3D printer is connected to the electrical network with an INPUT of 110 or 240 VAC,
50/60 Hz, and has an operational voltage of 12 V.
- Do not allow anything to rest on the power cord. Do not locate this product where
people will walk on the cord.
- If an extension cord is used with this product, make sure that the total ampere rating
of the equipment plugged into the extension cord does not exceed the extension
cord ampere rating. Also, make sure that the total rating of all products plugged
into the wall outlet does not exceed the fuse rating.
- Do not overload a power outlet, strip or receptacle by plugging in too many devices.
- Use the product only with the supplied power supply cord set. If you need to
replace the power cord set, make sure that the new power cord meets the
¯ŸĶĶŸɠÞضNjsLJȖÞNjsŎsŘǼǣʲ_sǼOÌEĶsǼɴƼsʰȕĵĶÞǣǼs_ˀNǢOsNjǼÞʩs_ʰə^rƼƼNjŸɚs_
or its equivalent, 4.5 meters (15 feet) maximum
- In case of malfunction disconnect the printer immediately from network.
˚^ŸŘŸǼǼǼsŎƼǼǼŸʩɮǼÌÞǣƼNjŸ_ȖOǼEɴɴŸȖNjǣsĶ¯ʰǣŸƼsŘÞضŸNjNjsŎŸɚÞضOŸɚsNjǣŎɴ
expose you to dangerous voltage points or other risks. Refer all reparation to
LJȖĶÞʩs_ǣsNjɚÞOsƼsNjǣŸŘŘsĶʳ®ŸNjOŸŘǼOǼǼÌsǼsOÌŘÞOĶǣsNjɚÞOsƼĶsǣsǣsŘ_ŘsŎÞĶ
to your national supplier or www.wanhao3dprintr.com
ȕŘƼĶȖ¶ǼÌÞǣƼNjŸ_ȖOǼ¯NjŸŎǼÌsɠĶĶŸȖǼĶsǼŘ_Njs¯sNjǣsNjɚÞOÞضǼŸLJȖĶÞʩs_ǣsNjɚÞOsƼsNjǣŸŘŘsĶ
when:
- The power cord or plug is damaged, cut or frayed.
- Liquid was spilled into the product.
- The product was exposed to rain or water.
- The product has been dropped or the case has been damaged.
- The product exhibits a distinct change in performance, indicating a malfunction.
- The product does not operate normally after following the operating instructions.
- Keep the printer out of the reach of small children.
Disposal instructions
Do not throw this electronic device into the waste when discarding. To minimize pollution and
ensure utmost protection of the global environment, please recycle or return to Photocentric
for recycling.
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator 7
6
