25
Inbetriebnahme
6. Initial start-up
After the Web-IO has been properly installed and wired, the power supply can be
switched on. All three status LEDs should light up briefly. After approx. 5 seconds
only the Power LED should remain on. The Status LED may flash. If a valid signal is
detected on one of the inputs, the corresponding LED also lights up.
If the network connection is working, the green LED in the network socket signals an
active link. The orange LED indicates the network speed:
On = 100MBit/s
Off = 10MBit/s
Assigning the IP address
At delivery, the Web-IO is set to IP address 0.0.0.0.0 and DHCP is activated.
Networks with DHCP
If a DHCP server is active in the network to which the Web-IO is connected, an IP
address should be automatically assigned to the Web-IO. To be able to specifically
access the Web-IO, you should configure a reservation in the DHCP server so that
the Web-IO is always accessible under the same address. The required Ethernet
address can be found on the white sticker on the device.
xxx
(If in doubt ask your network administrator)
Networks without DHCP
Install the WuTility program on a Windows PC (download from
http://www.WuT.de
).
If you do not have a Windows PC, read the subchapter
Alternatives for IP address
assignment
in the appendix.
When WuTility is started, the local subnet is scanned and all detected W&T network
components are listed. Select your Web-IO and click the
IP address
icon. WuTility
