wallas Spartan, Installation, Operation And Service Instructions

Page: 51 / 109

- 49 -
Water hosing
• Accumulator tank is installed if necessary
• Mixing valve must be installed if Wallas on-demand hot water accumulator is used
• Fresh water maximum usage pressure is 3 bar.
Do not attach to water supply network without pressure
reducer.
• Use purposed hot and cold fresh water pipes/hoses only
Initial start-up
• The device usually does not start the first time after it has been installed. It may take several starts (c. 4-6) for the
fuel hoses to fill up enough for the fuel to reach the burner.
• Watch the hoses as they fill up as you start the device.
• After two unsuccessful start-ups, the device will lock.
• Follow the instructions for unlocking the device and try again.
• When the device starts, look for possible leaks in the exhaust and fuel connections.
• Run the device for c. ½ hour to allow possible installation and manufacturing greases to burn off. Make sure there
is enough ventilation.
Remember to carefully read the instructions for installing, operating and servicing each device before
installation.
To be filled in by the installer
Test-run performed
Serial number
Company
Installer
Installation date
Signed