34
Pro Dry Instruction Manual
|
Walker Filtration
|
www.walkerfiltration.com
35
1.4 mm Hole
0.8 mm Hole
Figure 6.20: PD004 - PD035 Diaphragm changeout stage 1
Diaphragm Replacement
Models PD004 – PD035 only
•
Remove front panel.
• Remove bonnets by means of four fixing screws.
•
Separate bonnet from valve block.
• Disconnect tubing from fitting on bonnet.
•
Remove diaphragm assembly.
•
Insert new Diaphragms and springs, ensuring Diaphragm
holes are clear.
Tools required
•
4mm hex key
Section 6:
Maintenance
Figure 6.21: PD004 - PD035 Diaphragm changeout stage 2
Important information
Ensure shutdown and start-up procedures are followed prior
to carrying out any maintenance work on the dryer.
Walker Filtration will not accept responsibility for physical
injury, damage or delays caused by failure to observe the
instructions in this manual and manuals provided with your
equipment.
1. Diaphragm
2. Spring
A Instruction Manual is included in the changeout kit to
assist Diaphragm Replacement
35
1.4 mm Hole
0.8 mm Hole
