WalkAbout Mother Bin, Operator'S & Parts Manual

Page: 24 / 101

OPERATION
2
20
Walkabout Mother Bin Operator Manual
20174000r1 (04-2022)
4. When connecting the PTO to a tractor, check the distance from end of PTO output shaft to center of drawbar pin hole.
5. Ensure that the machine is properly attached to the tractor using a drawbar pin with provisions for a mechanical
retainer. Make sure that a retainer such as a Klik pin is installed.
NOTE : It is important to pin the draw bar in the central location only.
6. Tires are shipped from factory at only 70 PSI (480 kPa) for ease of towing. Inflate to 100 PSI (690 kPa) before using .
7. Ensure that a safety chain on the hitch is installed.
8.
Check oil level in the tractor hydraulic reservoir. Add fluid if required.
9. Inspect all hydraulic lines, hoses, fittings and couplers for tightness. Tighten if there are leaks. Use a clean cloth to
wipe any accumulated dirt from the couplers before connecting to the tractor’s hydraulic system.
2.7 CONNECTING TO THE TRACTOR
1. Clear the area of bystanders and remove foreign objects from the machine
and working area.
2. Make sure there is enough room to back the tractor up to the bin hitch.
3. Start the tractor and slowly back it up to the hitch point.
4. Stop the tractor engine, place all controls in neutral, set park brake and
remove ignition key before dismounting.
5. Use the bin jack (1) to raise or lower the hitch to align with the drawbar.
6. Install a drawbar pin (2) with provisions for a mechanical retainer (3) such
as a KLIK pin. Install the retainer. The WMB is equipped standard with a
single tang hitch and must only be used with a clevis-type tractor draw-bar.
1-¾” or 2” pin must be used.
7. Install a safety chain (4) between the tractor and the hitch.
IMPORTANT
The Walkabout Mother Bin should always be parked on a level, dry area that is free of debris and foreign objects. Follow
this procedure to connect the bin to the tractor.
1
4
3
2