![background image](http://html1.mh-extra.com/html/walinga/airlock-1008/airlock-1008_operators-manual_4518273070.webp)
OPERATOR’S MANUAL
4. Rotate the rotor by hand to inspect the condition of each blade, looking for any that are
bent, chipped, cracked, or otherwise broken. Replace any damaged blades with
reference to the section
Rotor Blade Tip Clearance Adjustment
.
Note:
if only one edge
of the tip is minimally damaged, it may be possible to use the other edge. Stainless steel
tips may be reground to a ‘true’ edge; this may be repeated until there is no longer
sufficient adjustment in the screw slots. Badly damaged tips
must
be replaced.
5. Use a feeler gauge to check the clearance between the tip and casing along the blade’s
entire length. Measure the clearance with reference to the casing edge opposite to the
wiper blade, as shown in
Figure 7-18
(the casing edge on the side of the wiper blade
experiences greater levels of normal operational wear, meaning measurements taken in
reference to this edge may result in clearances lower than the minimum allowable
clearance, resulting in scraping or damage between the tips and casing). Reference
Table 7-2
for tip clearance requirements. Rotate the rotor by hand and repeat the
clearance measurement for each tip.
Figure 7-18: Inlet/top tip clearance
7-16
00-144477-0 A
MAINTENANCE AND ADJUSTMENTS
Summary of Contents for Airlock 1008
