OPERATOR’S MANUAL
INITIAL SET-UP
To ensure safe and efficient operation, upon complete assembly and before initial use of the
machine, perform the following inspections:
● Ensure the dust hazard analysis as required by NFPA 652 has been completed and the
incorporation of the Walinga equipment complies with all relevant standards and
regulations.
● Ensure the area is clear of any bystanders and individuals not involved in the operation
of the machine, especially small children.
● To maintain proper stability, ensure all equipment is located on a flat surface that is solid,
dry and clear of any other equipment. As applicable, engage the holding brake (if fitted),
place wheel chocks, and anchor equipment securely.
● Ensure that any individuals involved in the operation of the machine or in close proximity
to the machine are equipped with the required personal protective equipment as outlined
in
Section 4: Safety
, including but not limited to: a hard hat, protective shoes with
slip-resistant soles, protective glasses or goggles, heavy gloves, wet weather gear, and
hearing protection. Long hair and loose clothing must be secured and jewelry should be
removed to avoid personal injury as a result of coming into contact with moving or
rotating components.
● Check to ensure all lubrication and grease points have been properly lubricated.
Reference
Section 7: Maintenance and Adjustments
for detailed lubrication
procedures and the required lubrication frequency.
● Check to ensure all guards are correctly positioned, closed and secured before
operation to prevent any personal injury or damage. All guards must be closed and
secured with fasteners before any operation.
● Ensure all mechanical locks, anchor chains, and any other transport devices that would
hinder or prohibit the normal function or movement of the airlock are removed. Serious
damage to the machine and/or personal injury to the operator or bystanders may result
from attempting to operate the machine while mechanical locking devices are attached.
MACHINE LIFE-CYCLE PROCEDURES
00-144475-0 A
5-3
Summary of Contents for Airlock 1008
