OPERATOR’S MANUAL
MACHINE SAFETY SIGNS
The safety signs affixed to the airlock and auxiliary equipment provide important information
regarding your safety and the safe operation of the machine. Familiarize yourself with all safety
signs before operation.
● Safety signs must be clean and legible at all times.
● Replace any safety signs that are missing, damaged, or have become illegible.
● Any replaced parts that previously displayed a safety sign, must display the current
safety sign.
● Safety signs are available at no cost from your representative, dealer, or directly from
Walinga.
If a safety sign has become damaged, illegible or a new safety sign must be installed on a
replacement component, proceed as follows:
1. Ensure the installation area is clean and dry
2. Ensure the temperature of the equipment is above 50 °F (10 °C).
3. Locate the correct position of the safety sign before removing the backing paper.
4. Remove the smallest portion of the split backing paper.
5. Align the safety sign over the correct position and carefully press the small portion with
the exposed adhesive backing in place.
6. Slowly peel back the remaining paper and carefully smooth the remaining portions of the
safety sign in place.
7. Small air pockets can be pierced with a pin and smoothed out using the backing paper.
Safety signs affixed to pneumatic conveying equipment are standardized as follows:
● Danger safety signs are red in color
● Warning safety signs are orange in color
● Caution safety signs are yellow in color
● Informational safety signs are white or blue in color
● Each safety sign is printed with its respective Walinga part number located in the bottom
right corner. Reference this number on the safety sign, or identified in the following
reproductions, to obtain replacement safety signs.
Due to the wide variety of pneumatic conveying systems that utilize an airlock, refer to the
operator’s manual of the auxiliary equipment for the exact location, quantity and part number of
each safety sign. The following safety signs are commonly used in close proximity and in
relation to an airlock:
SAFETY
00-144474-0 A
4-7
Summary of Contents for Airlock 1008
