WAGO 2857-570/024-001, Manual

Page: 81 / 120

2857-570/024-001 Configuration with the Interface Configuration Software
Product manual | Version: 2.0.0 81
3-Phase Power Measurement Module, 1 A
Figure 36: Tab Device
Table 78: Tab Device
Menu Item Description
Select Open the product selection to select a new product
(see
8 Starting the Software [ } 77] ).
Disconnect
Connect
Connects/disconnects the connected product to/from
the software
Settings Opens the dialog Settings .
Calibration Used to calibrate the connected product.
Snapshot Creates a snapshot of all parameters and measured
values, which can be stored as a CSV file.
Update Performs a firmware update on the product. A current
firmw are update and corresponding information on
compatibility can be obtained from WAGO Technical
Support.
Restore Not available for this product.
Dialog Settings
In this dialog, you can modify settings for the product. Two options are available:
• Online: The option
[Save to Device] writes the settings directly into the product.
• Offline: With this option, the settings must be saved externally using [Export] . If a
product is connected to the software later on, you can import these settings into the
software with the
[Import] button and then write them directly to the product with [Save
to Device] .
The settings can be made in the following sections:
• Device settings
• Phase L1
• Phase L2
• Phase L3
• Phase N
• Date/Time
• Energy
• Modbus
• Factory settings
• SD card
Changes that have been made but not yet saved are marked with the pencil symbol.
Buttons
The buttons apply generally and are identical in all sections.
Figure 37: Dialog settings – Buttons