WAFER GSM-HOUSE INTERCOM UNIT
http://www.waferstar.com
Acknowledge
: ALARM01 SET TO 61143815 OK
When the number is seted to 000000,that means delete the number in this position
(2)
check which is the number in a place of the alarm phone list:
#PWD123456#ALARM01?
(PC$PHONE)
Acknowledge
: ALARM01 IS 61143815 OK
(3)
List all numbers in the alarm phone list:
#PWD123456#ALARM=ALL?
(PC$PHONE)
Acknowledge
: ALARM IS XXXXX:XXXX:XXXXXXX:0000:0000
(Will show total five numbers, if no effective number,that will be replaced with 0000 )
(4) Alarm mode setup
(
PC$PHONE
)
There are two alarm input ,you can set at PHONE or SMS
#PWD123456#ALARM-IN1=ON:PHONE:10,ALARM-IN2=OFF
（
PC$
PHONE
）
Acknowledge
: ALARM_IN1=ON:PHONE:10,ALARM_IN2=OFF OKAY
#PWD123456#ALARM-IN1=ON:SMS:300,ALARM-IN2=ON:PHONE:10
（
PC$
PHONE
）
Acknowledge
: ALARM_IN1=ON:SMS:300, ALARM_IN2=ON:PHONE:10
If at phone mode: when receive the alarm input,then will phone the number in the alarm phone list until you
reject the phone call or that will continue to phone the number again after the minutes setted.
If at SMS mode: When receive the alarm input,then will send the SMS to the number in the alarm phone list
until you send the SMS to PAUSE the alarm .
(5) Config the SMS TEXT :
(PC)
#PWD123456#UDI1:XXXXXX, UDI2:XXXXXX
Acknowledge
: UDI1:XXXXXX, DI2:XXXXXX OKAY
(When the Alarm input is triggered,then will send the
SMS you already setted with this UDI command)
Check the text set
#PWD123456#UDI?
Acknowledge:
UDI1:ABC1, UDI2:ABC2
#REPORT Report the system status change
(PC$PHONE)
When setup to:
#PWD123456#REPORT=ON
Acknowledge
:
REPORT SET TO ON
Then any device status change would send the alarm SMS to Alarm01 number
#PWD123456#REPORT=OFF
Acknowledge
:
REPORT SET TO OFF
No report for the device status change
#PWD123456#REPORT?
You will receive the SMS reply:
REPORT IS ON
or
REPORT IS OFF
Check the REPORT setting status
#CSQ Check GSM signal quality
.
(PC$PHONE)
This command is useful to see what is the GSM network
