WAFER GSM-HOUSE INTERCOM UNIT
http://www.waferstar.com
verify the SIM card to call other phone and send and receive the SMS).
Lock the SIM card in the right direction:
GSM-HOUSE also comes with additional 2 Input.The inputs can be used to generate alarms
when triggered. For examples,you can can connect the door or gate saftey beam output to the
GSM-HOUSE Alarm1 and Alarm2 input.
Before the following test and programming,connect the DC12V properly to the DC12VIN
and GND.
After the device successfully connected to the GSM net,the LED on the Call button would
flash around 5 seconds per time.then we can start the following test:
WAFER GSM-HOUSE PROGRAMMING
You can program the GSM-HOUSE with SMS commands using your phone. It is safe to do
so because in addition to the fact that other people may not know the number of the SIM inserted
in it, we also use a Password that makes it impossible for anybody who doesn't know it to access
the system by chance.
Remember that commands must be CAPITAL LETTERS. It is PWD not pwd, CAP not Cap
etc. Don't add spaces or any other character.
Some complicated Instructions,that cann’t be programmed by the phone SMS. That would
need to use the PC software to program and inquire the status of the terminal.
1.Slide back the SIM door and
lift it up
2.Slide the SIM Card into the
SIM door making sure that
the clipped corner of the SIM
card lines up with the clipped
corner of the SIM holder
3.Close the SIM door
4.Slide the SIM door to lock the
SIM card in place
