WAFER GSM-HOUSE INTERCOM UNIT
http://www.waferstar.com
OPERATION mode:
Visitor mode:
When the visitor pushes the call button,the device initiates a voice call to the configured phone
number,if the called party accepts the call,the communication establishes for the configured
duration.During the call,the connection cann’t be stopped by pressing the button again.The call is
ended automatically when the configured communication time expires or the called party ends the
call. The call is ended automatically if the called party doesn’t answer or is not available.The
secondary numbers is called if the primary is not answered.
Controlling the relay output
The DOOR RELEASE (normally open,NO) relay output can be controlled as follows,depending
on the usage:
9
Controlling during the intercom call:
During a call,the user press 111 to open the relay1 and press 222 to open the relay2
9
Controlling by free call
On incoming call,after indentifying the caller ID,the unit reject the call and activates the
output,maximum 200 numbers can be configured
9
Controlling by SMS command or customized command
Please refer to the following SMS command to control the relay1 and relay2 and also can use the
customized SMS command to control
Adjust the sound volume
During intercom calling,press the * and # to increase or decrease the sound volume
Teach button (Device reset button)
Press the KEY button to Teach
Press the KEY and hold the button for around 2 second, the LED D7 would be lit,and then use
your phone to call the device number. when coming the call, the device would reject the calling
and D1 would flash one or two times, then the number is saved into the device memory, if you
need to program more, then just continue to use other phones to call the device. After program,
press the button again to quit the teaching. then the LED D1 would be extinguished.
(Fast button only program WHL position from WHL01 to WHL10)
Press the KEY button to Reset
Press the KEY button and hold the button for around 10 seconds,and then the LED would start to
flash and then release the button ,the device is reseted.the Password would be reseted to 123456
and from WHL01 to WHL10 would be cleared.and ACM=OFF,REPLY=ON,REPORT=ON all are
reseted.
