WAFER GSM-HOUSE INTERCOM UNIT
http://www.waferstar.com
signal level your GSM-HOUSE is receiving. It ranges from 0 to 32 (if it is 0 we doubt it will
ever answer...). You should have a signal above 12 to be sure of being able to open the
gate in any condition. Better if above 16. You should add an external antenna if this is not the case,
or eventually even change operator with another that serves your area better.
#PWD123456#CSQ?
Acknowledge:
CSQ IS 26
#MODE Relay Operation Mode SETUP
(PC$PHONE)
#PWD123456#MODE0
Acknowledge
: RELAY SET TO MODE0
#PWD123456#MODE1
Acknowledge
: RELAY SET TO MODE1
If set to MODE0,that is
Momentary pulse and If Config to MODE1,that is Ratchet relay
#STATUS Check the config information of the terminal
(PC$PHONE)
#PWD123456#STATUS?
You will receive a Acknowledge with:
Acknowledge
:
ALARM1=OFF:SMS:12,ALARM2=OFF:SMS:10,GOT=05S,WHL=02,ALAR
M1=HIGH,ALARM2=HIGH,BCPW=69,CSQ=20,RELAY1=OFF,RELAY2=OFF
(BCPW is the remaining power )
#OUT Control the Relay Output on or off
(PC$PHONE)
#PWD123456#OUT1=ON
or
OFF
Acknowledge
:OUT1 ON OK
or
OUT1 OFF OK
#PWD123456#OUT2=ON
or
OFF
(If has the second relay output on board)
Acknowledge
:OUT2 ON OK
or
OUT2 OFF OK
Customized output control command TEXT:
(PC$PHONE)
#REPLY SMS reply OFF or ON
#PWD123456#REPLY=ON
Acknowledge
:REPLY SET TO OFF
When setup to ON,then Device will reply the customized command after Relay is toggled
#PWD123456#REPLY=OFF
Acknowledge
:REPLY SET TO OFF
When setup to OFF,then Device will not reply the customized command after Relay is toggled
(This command is used to save the cost for user)
With these command you can customize the command to control your output.then would be easy
for you to understand the command
#PWD123456#OPEN1-TEXT#XXXX
#PWD123456#CLOSE1-TEXT#XXXX
#PWD123456#RLY-TEXT1#XXXX
If have the second output reply,then use the following command to config the second output
#PWD123456#OPEN2-TEXT#XXXX
#PWD123456#CLOSE2-TEXT#XXXX
#PWD123456#RLY-TEXT2#XXX
