WAFER GSM-HOUSE INTERCOM UNIT
http://www.waferstar.com
#PWD123456#SHL=ALL?
(Instruction Only for
PC)
Acknowledge
:
SHL01 IS XXX
SHL03 IS XXX
QHL08 IS XXX
……
#QUERY Query the phone number in the WHL list.
(
PC$PHONE)
Query the phone number in the position of the WHL list,Special phone list or Alarm phone list
#PWD123456#QUERY=143535353
(
PC$PHONE)
Acknowledge
: QUERY RESULT: 143535353 AT WHL004
#ACM Safety control or free control mode setting.
(
PC$PHONE)
#PWD123456#ACM=ON
Acknowledge
:ACM SET TO ON
#PWD123456#ACM=OFF
Acknowledge
:ACM SET TO OFF
ACM=OFF, Then any number can free control the device through the phone calling
ACM=ON, Then only the authorized number can control the device through the phone calling
#GOT Relay working output delay time.
(
PC$PHONE)(Only for NO.1 Relay)
When setup the GOT Timer,first you also need to setup the timer
multiplier at millisecond or second
or minutes.
#PWD123456#GOT5000:MILLISECOND
Acknowledge
:DELAY TIME SET TO 5000 MS
#PWD123456#GOT500:SECOND
Acknowledge
:DELAY TIME SET TO 0500 S
#PWD123456#GOT500:MINUTE
Acknowledge
:DELAY TIME SET TO 0500 M
This command is useful in case you need to keep the Relay output working longer. The standard
time is 5 seconds (5000 ms). You can change it with the GOT command.
With the above command the delay time has been set to 5000 ms (5 seconds).
You can check what the current relay output delay time is with the command
#PWD123456#GOT?
(
PC$PHONE) (Only for NO.1 Relay)
Acknowledge
:
DELAY TIME IS 05000 MS
#ALARM Alarm setup
In GSM-HOUSE V2015,that Alarm01 is very important position,not only act as a alarm number,but also
working as the REPORT phone number, that means if you enable the REPORT function,then every report
event happen,then would send the REPORT SMS to this number
(1)You can setup the alarm phone number when have the alarm information input
#PWD123456#ALARM01=13818120592
(
PC$PHONE)
Where 01 is the position in the list
