Waeco MagicSafe MS150, Installation And Operating Manual

Page: 39 / 208

39
If the hand transmitter should not function any more or is lost, you have
to open the door by key. The alarm system will react immediately.
To cancel the alarm and disarm the system, proceed as follows:
Turn the ignition on and off twice and then turn
the ignition on within a 7 second period.
The LED flashes fastly for 3 seconds. After this
3 seconds period, the LED will start to flash once
per second. After the number of flashes equal to
the tens digit of your PIN code, turn the ignition off.
Turn the ignition on.The LED will flash continuously
for 1 second. After this 1 second period, the LED
starts to flash once per second. After the number
of flashes equal to the units digit of your PIN code,
turn the ignition off.
The alarm system is disarmed. If the PIN code is
incorrect, a new alarm is resounded. If an incorrect
PIN code is entered 3 times, all PIN code operations
will be blocked for 3 minutes.
The factory adjusted PIN code is 11.
Disarming of the alarm system in case of emergency
MSK-150_09092003.qxd 16.03.2004 8:19 Uhr Seite 39
If the siren beeps are enabled on arm and disarm this will not comply
with the 95/56/EC regulations.If the voltage detection is also
switched on, this will also not comply with 95/56/EC regulations.