Wacker Neuson Trowel CT 24-4A, Operator'S Manual

Page: 30 / 68

wc_tx003232gb.fm
30
Operation CT 24-4A
4.12 Position of the Operator
Safe and efficient use of this machine is the operator’s responsibility. Full control of
the machine is not possible unless the operator maintains the proper working
position at all times.
While operating this machine the operator must:
„
stand or walk behind the machine, facing forward;
„
have both hands on the control handle;
„
and guide the motion of the trowel by applying downward pressure to the control
handle
4.13 Operation
Test the function of the Operator Present Lever before operating the trowel. Do not
operate the trowel if the Operator Present Lever is not functioning properly.
Choose correct blade type and attach blades to trowel arms.
Note: When operating on soft concrete, do not let trowel stand in one spot too long.
Always lift trowel from slab when operation is complete.
Note: “Left” and “Right” references are made from the operator's position.
1. Start engine and engage blades by increasing engine speed. Set speed with
throttle control on handle bar to appropriate speed for job conditions.
2. To move trowel forward twist handle clockwise (a) .
3. To move backward twist handle counterclockwise (b) .
4. To move to the left lift up slightly on the handle (c) .
5. To move to the right press down slightly on the handle (d) .
6. Clean trowel after each use to remove concrete splatter.
Allow the muffler to cool before cleaning or servicing the machine. A hot muffler
could ignite the fuel and start a fire.
Personnel other than the trowel operator should not be allowed in the work area, as
severe injury can occur from contact with operating trowel blades.
Do not attempt to clean, service or perform adjustments on the trowel while it is
running.
WARNING
WARNING
WARNING