Wacker Neuson Trowel CT 24-4A, Operator'S Manual

Page: 28 / 68

wc_tx003232gb.fm
28
Operation CT 24-4A
4.9 Before Starting
Before starting trowel, check the following:
„
oil level in engine
„
oil level in gearbox
„
fuel level
„
condition of air filter
„
condition of fuel lines
„
condition of trowel arms and blades
„
condition of ring guard
„
label descriptions
„
adjustable lever is tight
4.10 Starting
1. Open fuel valve by moving lever to the right (g1) .
Note: If engine is cold, move choke lever to closed position (i1) . If engine is hot, set
choke to open position (i2) .
2. Turn engine switch to “ ON ” (h1) .
3. Move the throttle lever to the idle position (c1) .
Start engine with throttle in the IDLE position. If the engine is started when the
throttle is not in the IDLE position, the trowel blades may spin unexpectedly and
cause injury.
4. Squeeze and hold the Operator Present Lever (b) .
5. Pull starter rope (j) .
Do not place foot on the ring guard when starting the engine, as severe injury can
occur if foot slips through the ring guard as the blades start to spin.
Note: If the engine oil is low, the engine will not start. If engine does not start,
check the oil level and add oil as needed.
6. Open choke as engine warms (i2) .
7. Open throttle (c2) to operate trowel. Adjust blade RPM with throttle speed to suit
conditions.
WARNING
WARNING