Wacker Neuson RD24, Instruction Manual

Page: 167 / 228

Tables
Technical data
BA RD24_RD27 en 04 167
5.00.02 Fuel
Use only the diesel fuel commercially available which contains a sulphur
content below 0.5 %. The engine oil replacement intervals specified here
apply only for diesel fuel.
Approved diesel fuel specifications are:
■
DIN EN 590
■
ASTM D 975 Grade-No. 1-D and 2-D
■
JIS K 2204 Grade 1 Fuel and Grade 2 Fuel, with lubricating
properties corresponding to diesel fuel EN 590 (HFFR max. 460
micrometer in accordance with EN ISO 12156)
In case other fuels are used that do not comply with the afore mentioned
requirements, we do not accept any guarantee.
With diesel fuels with a sulfur content over 0.5 % to 1.0 % or permanent
ambient air temperatures below –10 °C (–14 °F) the change intervals of
the motor oil need to be halved.
N O T E
The certification measurements to measure the compliance
with statutory emission limits are carried out using the test
fuels specified by law. These test fuels correspond to the diesel
fuels that comply with EN 590 and ASTM D 975, which are
described in this operating manual. For all other fuels specified
in this instruction manual we cannot guarantee any emission
value.
Winter operation with diesel fuel
NOTICE
Low operating temperature!
Congestions of the fuel system by paraffin excretions at low operating
temperatures.
■
Use winter diesel fuel for working at temperatures between 0 °C
(32 °F) and –20 °C (–4 °F).
■
For use below –20 °C (–4 °F) add petroleum according to
manufacturer's instructions.
■
Use special diesel fuels for working in arctic climatic zones with
temperature down to –44 °C (–47 °F).