MIO-R290GM2011 Rev E
G&B Specialties Inc. 535 West 3
rd
Street, Berwick, PA, USA Tel: (570) 752-5901 Fax: (570) 752-6397
US Field Service: 570-441-6988; CAN Field Service 570-854-0482; www.rafna.com
-80-
10.
Re-install the vehicle bumper and other components as required.
11.
Manually rotate the railgear up to the road position. Take note of if and where the
railgear, rail wheels, and/or rail sweeps contact the vehicle bumper and or exhaust. Trim
and reinforce the bumper as required. Ensure there is enough clearance to accommodate
side-to-side adjustment and rail wheel load adjustment of the railgear. The exhaust
system can be bent to fit around the railgear. Ensure any exhaust system modifications
conform to applicable laws and regulations. Proceed to install the railgear hydraulic
system as per the Hydraulic Kit Installation manual before continuing with the following
steps.
12.
Standard/In-Cab Controls Only:
a)
The locking cable is supplied with a bulkhead fitting to ease installation. Ensure that
the “Pull to Unlock” placard is on the cable end.
13.
Follow the Railgear Over-Center Adjustment procedure detailed in the Railgear Kit
Operation, Service and Parts manual. Ensure the cylinder rod-end lock nut is re-tightened
following this adjustment.
14.
Standard/In-Cab Controls Only:
15.
With the railgear fully raised to the road position, ensure that the railgear lock pin
properly engages the lock cam. It may be necessary to grind the lock cam slightly to
ensure proper fit.
16.
Standard/In-Cab Controls Only:
a)
Note that some hydraulic kit installations provide a lock cam converter to prevent the
railgear lock pin from engaging in the rail position. If such a lock cam converter was
installed, skip this step. Otherwise, with the railgear fully lowered to the rail position,
ensure that the railgear lock pin properly engages the lock cam. It may be necessary to
grind the lock cam slightly to ensure proper fit.
17.
Follow the Rail Wheel Load Adjustment procedure detailed in the Railgear Kit Operation,
Service and Parts manual.
18.
Follow the Railgear Alignment procedure detailed in the Railgear Kit Operation, Service
and Parts manual.
19.
Follow the Rail Sweep Adjustment procedure detailed in the Railgear Kit Operation,
Service and Parts manual.
20.
Torque all fasteners as detailed in the Railgear Kit Operation, Service and Parts manual.
21.
Grease the railgear at all lubrication points as detailed in the Railgear Kit Operation,
Service and Parts manual.