MIO-R290GM2011 Rev E
G&B Specialties Inc. 535 West 3
rd
Street, Berwick, PA, USA Tel: (570) 752-5901 Fax: (570) 752-6397
US Field Service: 570-441-6988; CAN Field Service 570-854-0482; www.rafna.com
-194-
I
NSTALLATION OF
S
TEERING
W
HEEL
L
OCK
Steering Wheel Lock Kit Components
Part Number
Description
Qty
S-001050
Steering Wheel Lock
1
S-001040
Steering Wheel Lock Decal
1
R-21163 Speed
Decal
1
1.
Ensure the front wheels are pointing straight ahead and the steering wheel is centered
before installation.
2.
The steering wheel lock consists of one steering wheel lock patch with RAFNA logo and
three adhesive back strips.
3.
Without removing the protective backing, position one adhesive back strip on top of the
steering column cover and another on the steering wheel. The strips should be close
enough together so that the patch will cover both when the steering wheel lock is
engaged. Ensure that the adhesive back strips do not interfere with any devices, such as
the hazard light button on the steering column cover or the air bag cover on the steering
wheel. Modify the adhesive back strips as required to clear any obstructions. Mark their
locations on the steering column cover and the steering wheel.
4.
Without removing the protective backing, position the third adhesive back strip in a
convenient location on the dash (so that it does not interfere with the view and/or
operation of the vehicle). This adhesive back strip will serve as a holder when the steering
wheel lock is disengaged. Mark the location.
5.
Scuff the three areas previously marked with medium / fine sandpaper. The areas should
be free of dust, dirt, and any oily residue. Thoroughly clean the areas with denatured
alcohol or a similar non-oil-based degreaser that will not react with the plastic. Let dry.
6.
Take care when placing the adhesive back strips; once they are applied, they should not
be removed. Do not touch the adhesive with your fingers. Removing the adhesive back
strips once installed or touching the adhesive may cause poor adhesion.
7.
Peel off the protective backing from the adhesive back strips. Firmly press them into
place as previously located. Do not disturb the adhesive back strips for 24 to 30 hours to
allow the adhesive to fully cure.
8.
Store the steering wheel lock patch on the adhesive back strip located on the dash.
9.
Stick the steering wheel lock decal in a highly visible spot on the dashboard.
10.
Stick the maximum speed decal in a highly visible spot, within clear sight of the operator,
on the dashboard.
