![background image](http://html1.mh-extra.com/html/wabrotech/wt20i/wt20i_operating-instructions-manual_3098526034.webp)
Leave the supply valve in the overflow position until you are ready to spray again. If you suspect that the spray
tip or hose is clogged or that the pressure has not been fully relieved after following the steps above, VERY
SLOWLY loosen the tip guard or hose end to relieve pressure gradually, then loosen completely. Clear the
hose or clogged tip. If we see that the nozzle is clogged, the first quickest option is to turn it 180 degrees and
pull the trigger to direct the outlet into the bucket.
To thoroughly clean the nozzle, pull it out completely. Remember to release the pressure and turn off the unit
before removing it. Then unscrew the nozzle holder, then we can pull out the nozzle together with the nozzle
seal. These elements can be washed in warm soapy water.
Trigger Lock
Always engage the trigger lock when you
stop spraying to prevent the gun from being
accidentally triggered by hand or if dropped
or bumped.
2. Turn the supply valve to the flow position
to relieve pressure.
3. Hold the gun firmly against the side of
the bucket.
Pressure Relief Procedure
Follow this
Pressure Relief Procedure
each time you stop spraying and before cleaning, checking,
servicing, or transporting equipment.
1. Turn off the power and disconnect the power cord.
4. Engage trigger lock.
WABRO sc ul. Arki Boÿek 2A, 41-910 Bytom
NIP: PL6263032331 | Regon: 381911373
Wabrotech.pl
4. ACTION
ATTENTION!
8
Machine Translated by Google